RhinoFabStudio

Parametric Design + Optimization + Digital Fabrication

I batted around the idea of titling this one "Just After the Big Bang" or "Origin of the Universe" or some such - but I decided to simplify. Nonetheless, to me it represents what the Universe could have looked like just a few Planck Time units after the Big Bang, with a lot of artistic license thrown in for good measure. I started with a simple egg-shaped surface in Rhino, then used the built-in Paneling Tools to array the hexagonal base unit over said surface. LOTS of flailing around and reiterating until I finally got something that would work. One complication of this particular design that normally doesn't occur in my Rhino work is the thickness of the material - because it incorporates repeating components, the thickness of each one must be allowed for in order for the pieces to properly form the correct final shape. This is one area that Rhino struggles in, as it employs surfaces that are zero-thickness rather than solids with volume like real-world sheet metal. I imported the surfaces into Solidworks and added the appropiate thickness, but then had to pull them back into Rhino to produce the correct patterns for the laser cutter - Solidworks is just too rigid to allow my crazy shapes to be modeled with its sheet metal tools. Go figure. Anyway, this is what I ended up with, pared down to a quarter of the whole form. By: Mark Leichliter

More info at:

http://www.exocubicstudio.com

Views: 139

Comment

You need to be a member of RhinoFabStudio to add comments!

Join RhinoFabStudio

Translate Language:

RhinoFabStudio

Learn all about Rhino

© 2024   Created by Andres Gonzalez.   Powered by

Badges  |  Report an Issue  |  Terms of Service