Cap co2 controller instructions

To reset the unit, unplug the main power cord for 20 seconds and re-connect. CALIBRATION. The PPM-2a is factory calibrated. The sensor onboard the PPM-2a is The CO2-2e will control the temperature, humidity and CO2 levels within 11) Read the rest of the instructions to determine how to set the CO2 timers! The ZG10U CO2 Monitor is with the audible alarm and visual If cleaning places where the SEU is installed, first take off rubber cap off and putting itCaution: Move the rubber cap from position “M” to position “L” when is first removed from the packaging so that the vent is not blocked while the unit is. Connect any 120vac temperature / humidity controller to the PPM-2a to disable CO2 when the fans are operating. Standard 120vac, IEC-320 cable included. Fuse The C.A.P. PPM-3 is the easiest and most affordable CO2 Monitor & Controller available today. Use to accurately measure levels Instruction Manual (PDF). Overview. • The PPM-4 is a two-piece controller that includes a wall mounted infrared sensor with a 10 ft. cord and a plug-in pass-through controller/power